NETGEAR WAC510 - Page 193

If your browser does not open the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 41.
3. Enter the access point user name and password.
The user name is admin. The password is the one that you specified the first time
that you logged in. The user name and password are case-sensitive.
If you previously added the access point to a NETGEAR Insight network location and
managed the access point through the Insight app or Insight Cloud portal, enter the
Insight network password for that location. For more information, see Connect over
WiFi using the NETGEAR Insight App on an iOS or Android mobile device on page
26).
The Dashboard page displays.
4.
Locate the Radio Information pane at the top, right corner of the Dashboard page
(if the page width on your device is sufficient; otherwise, it might be elsewhere).
The following settings are displayed:
•
Radio status (If the 2.4 GHz or 5 GHz icon is displayed as gray, the radio is turned
off.)
•
Mode
•
Channel
•
Channel width
•
Number of connected clients and maximum number of supported clients
•
WiFi traffic volume
•
Channel utilization
5.
To view information for the 5 GHz radio, click the 5 GHz tab.
By default, information for the 2.4 GHz radio is shown.
User Manual193Monitor the Access Point and the
Network
Insight Managed Smart Cloud Wireless Access Point WAC510 User Manual