EasyManuals Logo

NETGEAR Wireless-N User Manual

NETGEAR Wireless-N
151 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #135 background imageLoading...
Page #135 background image
RangeMax Dual Band Wireless-N Modem Router DGND3300 User Manual
Troubleshooting A-4
v1.0, January 2010
LEDs never turn off. When the router is turned on, the LEDs turn on for about 10 seconds
and then turn off. If all the LEDs stay on, there is a fault within the
router.
If all LEDs are still on 1 minute after power up:
Cycle the power to see if the router recovers.
Clear the router’s configuration to factory defaults as explained in
“Restoring the Factory Configuration Settings” in Appendix B.
If the error persists, you might have a hardware problem and should
contact Technical Support at
www.netgear.com/support.
ADSL Link LED is off. Disconnect all telephones on the line. If this solves the problem,
reconnect the telephones one at a time, being careful to use a
microfilter on each telephone. If the microfilters are connected
correctly, you should be able to connect all your telephones.
Check that the telephone company has made the connection to your
line and tested it.
Verify that you are connected to the correct telephone line. If you
have more than one phone line, be sure that you are connected to the
line with the ADSL service. It may be necessary to use a swapper if
your ADSL signal is on pins 1 and 4 of the RJ-11 jack. The Dual Band
Wireless-N Modem Router uses pins 2 and 3.
Internet LED is red. The modem router cannot access the Internet. See “Cannot Access the
Internet” on page A-6.
The Ethernet port LEDs are off. If the Ethernet port LEDs do not light when the Ethernet connection is
made, check the following:
Make sure that the Ethernet cable connections are secure at the
modem router and computer.
Make sure that power is turned on to the connected modem or
computer.
Wireless LEDs are off. If the Wireless LEDs do not come on, verify that the Enable Wireless
Router Radio check box is selected on the Advanced Wireless
Settings screen. See “Configuring Advanced WPS Settings” on
page 2-17.
Table A-2. Troubleshooting with the LEDs
Situation Recommended Action

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR Wireless-N and is the answer not in the manual?

NETGEAR Wireless-N Specifications

General IconGeneral
Wireless SpeedUp to 300 Mbps
Frequency Band2.4 GHz
VPN SupportNo
Antennas2 external antennas
SecurityWPA, WPA2, WEP
Ethernet Ports4 x 10/100 Mbps LAN ports, 1 x 10/100 Mbps WAN port

Related product manuals