RangeMax Dual Band Wireless-N Modem Router DGND3300 User Manual
1-9 Configuring Your Internet Connection
v1.0, January 2010
Configuring ADSL Settings
NETGEAR recommends that you use the Setup Wizard to automatically detect and configure your
ADSL settings. This usually works fine. However, if you have technical experience and are sure of
the multiplexing method and virtual circuit number for the virtual path identifier (VPI) and virtual
channel identifier (VCI), you can specify those settings here.
If your ISP provided you with a multiplexing method or VPI/VCI number, then enter the setting:
1. From the main menu, select ADSL Settings to display the ADSL Settings screen.
a. In the Multiplexing Method drop-down list, select LLC-based or VC-based.
b. For the VPI, type a number between 0 and 255. The default is 8.
c. For the VCI, type a number between 32 and 65535. The default is 35.
d. Click Apply.
Note: For information about how to install ADSL filters, see the Setup Manual.
Note: NETGEAR recomments using the Setup Wizard to select the correct country to
optimize detection of the ADSL settings.
Figure 1-7
To Next Page
Loading...
Need help?
General
