RangeMax Dual Band Wireless-N Modem Router DGND3300 User Manual
B-1 Default Configuration and Technical Specifications
v1.0, January 2010
Appendix B
Default Configuration and Technical
Specifications
This appendix provides factory default settings and technical specifications for the RangeMax
Dual Band Wireless-N Modem Router.
Restoring the Factory Configuration Settings
This section explains how to restore the factory default configuration settings. This procedure
restores the admin user name password to password, and the IP address to 192.168.0.1. You can
erase the current configuration and restore factory defaults in two ways:
• Use the Erase function of the router (see “Erasing the Configuration” on page 4-11).
• Use the Restore Factory Settings button on the rear panel of the router. Use this method for
cases when the administration password or IP address is not known.
Using the Restore Factory Settings Button
To restore the factory configuration settings without knowing the administration password or IP
address, you must use the Restore Factory Settings button on the rear panel of the modem router.
1. Press and hold the Restore Factory Settings button until the Power LED turns red (about 6
seconds).
2. Release the Restore Factory Settings button and wait for the router to reboot.The Power LED
will blink red three times and then will turn green when the default configuration settings have
been restored.
Note: This procedure erases your current configuration, including your wireless security.
When you log in after resetting, you will be prompted to configure these settings.
To Next Page
Loading...
Need help?
General
