Basic Installation and Configuration
40
ProSAFE Dual Band Wireless N Access Point WNDAP350
To configure a Security Profile:
1. From your Web browser, log in to the WNDAP350 using the default LAN address of
http://192.168.1.1, user name admin and password password, or use the LAN address
and password that you set up.
2. Under the Configuration tab, select
Security from the main menu, and then select either
Security Profile Settings for 802.11b/bg/ng or 802.11a/na. The screen for the Profile Settings
you selected displays as shown in Figure 17, Security profile settings above.
3. Select the check box of the profile you want to modify and click Edit. The Security Profile
Configuration screen for the selected profile displays (see Figure 18, Edit a security profile).
Figure 18. Edit a security profile
4. Give your profile a meaningful name so that you can remember it later.
5. The Wireless Network Name (SSID) is set by default to identify it as NETGEAR_11g.
6. Enable or disable the Broadcast Wireless Network Name (SSID). It is enabled by default. (If
it is broadcast, it can be easily detected by other clients.)
7. From the Network Authentication pull-down menu, select the Network Authentication Type
you want to use for this profile:
• To configure WEP encryption for Open Systems or Shared Key, see Configuring WEP
on page 41.
• To configure WPA with RADIUS, see Configuring WPA with RADIUS on page 42.
• To configure WPA2 with RADIUS, see Configuring WPA2 with RADIUS on page 43.
• To configure WPA and WPA2 with RADIUS, see Configuring WPA and WPA2 with
RADIUS on page 44.
• To configure WPA-PSK, see Configuring WPA-PSK on page 45.
• To configure WPA2-PSK, see Configuring WPA2-PSK on page 46.
• To configure WPA-PSK and WPA2-PSK, see Configuring WPA-PSK and WPA2-PSK
on page 46.
To Next Page
Loading...
Need help?
General
