NETGEAR WNDAP350 User Manual

Management
58
ProSAFE Dual Band Wireless N Access Point WNDAP350
Enabling the SysLog Server
The SysLog screen allows you to enable the SysLog option if you have a SysLog server on
your LAN.
 To enable a SysLog server:
1. Under the Configuration tab on the main menu, select System, then select the
Advanced option, and select SysLog to view the screen shown in Figure 35, Enable
SysLog server.
Figure 35. Enable SysLog server
2. Enable SysLog. Enable this option if you have a SysLog server on your LAN. If enabled,
you must enter the IP address of your SysLog server and the port number your SysLog
server is configured to use. The default is Disabled.
3. SysLog Server IP Address. The access point will send all the SysLog to the specified IP
address if SysLog option is enabled.
4. Port Number. The port number configured in the SysLog server on your LAN. Default is
514.
5. Click Apply to save your SysLog settings.

NETGEAR WNDAP350 Specifications

General

Brand	NETGEAR
Model	WNDAP350
Category	Wireless Router
Language	English