NETGEAR WNDAP350 User Manual

Default Settings and Technical Specifications
95
ProSAFE Dual Band Wireless N Access Point WNDAP350
Factory Default Settings
You can use the reset button located on the front of your device to reset all settings to their
factory defaults. This is called a hard reset.
• To perform a hard reset, push and hold the reset button for approximately 5 seconds
(until the TEST LED blinks rapidly). Your device will return to the factory configuration
settings shown in Table 7 below.
• Pressing the reset button for a shorter period of time will simply cause your device to
reboot.
Table 7. Access Point Default Configuration Settings
Feature Description
AP Login
User Login URL 192.168.1.1
User Name (case sensitive) admin
Login Password (case sensitive) password
Ethernet Connection
Static IP Address 192.168.0.210
Ethernet MAC Address See bottom label.
Port Speed 10/100/1000
Local Network (LAN)
Lan IP 192.168.1.1
Subnet Mask 255.255.255.0
Gateway Address 0.0.0.0
DHCP Server Disabled
DHCP Client Disabled
Time Zone USA-Pacific
Time Zone Adjusted for Daylight Saving
Time
Disabled
SNMP Enabled, but Trap forwarding disabled
Spanning Tree Protocol Disabled
Secure Telnet Enabled

NETGEAR WNDAP350 Specifications

General

Brand	NETGEAR
Model	WNDAP350
Category	Wireless Router
Language	English