Troubleshooting and Debugging
82
ProSAFE Dual Band Wireless N Access Point WNDAP350
• If the WNDAP350 is configured correctly, check your Internet connection (DSL/Cable
modem etc.) to make sure that it is working correctly.
• Try again.
How do I use the Reset button to restore the factory
default settings?
The Reset button (see Rear Panel on page 13) has two functions:
• Reboot. When pressed and released quickly, the WNDAP350 will reboot (restart).
• Reset to Factory Defaults. This button can also be used to clear all data and restore all
settings to the factory default values.
To clear all data and restore the factory default values:
1. Power off the WNDAP350 and power it back on.
2. Use something with a small point, such as a pen, to press the Reset button in and hold it in
for at least 5 seconds.
3. Release the Reset button.
The factory default configuration has now been restored, and the WNDAP350 is ready for
use.
To Next Page
Loading...
Need help?
General
