Advanced Configuration
70
ProSAFE Dual Band Wireless N Access Point WNDAP350
3. Specify the following settings:
• HTTP Redirect. Enable HTTP Redirect.
• Redirect URL. Enter the URL of the Web server where you wish to redirect HTTP
(port 80) requests.
4. Click Apply. All port 80 requests will now be redirected to the specified URL.
Configuring Advanced Wireless Settings
The Advanced option of the Wireless Settings menu is used to configure and enable various
wireless LAN parameters for both the 11a/na and 11b/bg/ng modes. The default wireless LAN
parameters usually work well. However, you can use these settings to fine tune the overall
performance of your wireless access point for your environment.
The Wireless Settings option of the Advanced menu is used to configure the Wireless LAN
parameters. The default advanced wireless LAN parameter settings usually work well.
Configuring 802.11b/bg/ng Advanced Wireless Settings
To configure advanced Wireless Settings:
1. Under the Configuration tab, select Wireless.
2. From the sidebar, select Advanced, and then select Wireless Settings.
3. Select the 802.11b/bg/ng tab. The Advanced Wireless Settings screen you selected
displays, as shown in Figure 46, Advanced Wireless Settings - 802.11b/bg/ng.
Figure 46. Advanced Wireless Settings - 802.11b/bg/ng
4. Enter the appropriate information in the fields described below:
• RTS Threshold (0 - 2347). Request to Send Threshold. The packet size that is used
to determine if it should use the CSMA/CD (Carrier Sense Multiple Access with
To Next Page
Loading...
Need help?
General
