NETGEAR WNDAP350 User Manual

Basic Installation and Configuration
36
ProSAFE Dual Band Wireless N Access Point WNDAP350
SSID and WEP/WPA Settings Setup Form
802.11b/bg/ng Configuration
For a new wireless network, print or copy this form and fill in the configuration parameters.
For an existing wireless network, the person who set up or is responsible for the network will
be able to provide this information. Be sure to set the Regulatory Domain correctly as the first
step.
• SSID. The Service Set Identification (SSID) identifies the wireless local area network.
NETGEAR_11g is the default WNDAP350 SSID. However, you may customize it by
using up to 32 alphanumeric characters. Write your customized SSID on the line below.
___________________________________
Note: Note: The SSID in the wireless access point is the SSID you configure
in the wireless adapter card. All wireless nodes in the same network
must be configured with the same SSID:
• Authentication.
Circle one: Open System or Shared Key. (Choose Shared Key for more security.)
Note: If you select shared key, the other devices in the network will not connect unless
they are set to Shared Key as well and have the same keys in the same positions as
those in the WNDAP350.
• WEP Encryption Keys.
Circle one: 64, 128, or 152 bits. (Enter all four 802.11a/n keys for the Key Size chosen.)
Key 1:
___________________________________
Key 2:
___________________________________
Key 3:
___________________________________
Key 4:
___________________________________
• WPA-PSK (Preshared Key).
Record the WPA-PSK key. Key:
___________________________________
• WPA RADIUS Settings. For WPA, record the following settings for the primary and
secondary RADIUS servers:
Server Name/IP Address: Primary
_________________
Secondary
__________________
Port:
___________________________________
Shared Secret:
___________________________________

NETGEAR WNDAP350 Specifications

General

Brand	NETGEAR
Model	WNDAP350
Category	Wireless Router
Language	English