Basic Installation and Configuration
35
ProSAFE Dual Band Wireless N Access Point WNDAP350
- The use of passphrases and keys is explained below:
• Passphrase. To use the Passphrase to generate the WEP keys, enter a
passphrase and click the Generate Keys button. You can also enter the keys
directly. These keys must match the other wireless stations.
• Key 1, Key 2, Key 3, Key 4. If using WEP, select the key to be used as the default
key. Data transmissions are always encrypted using the default key. The other
keys can only be used to decrypt received data.
• WPA Preshared Key Passphrase. If using WPA-PSK or WPA2-PSK, enter the
passphrase here. All wireless stations must use the same passphrase (network
key). The network key must be from 8 to 64 characters in length.
• Wireless Client Security Separation. If enabled, the associated wireless clients will not
be able to communicate with each other. (This feature is intended for hotspots and other
public access situations.) The default is Disabled.
• VLAN ID. If the hubs/switches on your LAN support the VLAN (802.1Q) standard and this
feature has been enabled, the default VLAN ID for WNDAP350 will be associated with
each profile. The default Profile VLAN ID must match the IDs used by other network
devices.
AES This is the standard encryption method for WPA2.
TKIP + AES This setting supports both WPA and WPA2. Broadcast packets use TKIP.
For unicast (point-to-point) transmissions, WPA clients use TKIP, and WPA2
clients use AES.
Table 3. Data Encryption Settings
Data Encryption Type Description
To Next Page
Loading...
Need help?
General
