Management
60
ProSAFE Dual Band Wireless N Access Point WNDAP350
Figure 37. View system information
This screen shows the parameters listed in Table 4:
Table 4. System Information Fields
Field Description
Access Point Information
Access Point Name Indicates the NetBIOS name. The default name may be changed, if desired.
Ethernet MAC Address Displays the Media Access Control address (MAC address) of the wireless
access point’s Ethernet port.
Wireless MAC address for
2.4GHz
Displays the Media Access Control address (MAC address) of the wireless
access point’s wireless card when operating at 2.4GHz
Wireless MAC address for
5GHz
Displays the Media Access Control address (MAC address) of the wireless
access point’s wireless card when operating at 5GHz
Country/Region Displays the domain or region for which the wireless access point is licensed for
use. It may not be legal to operate this wireless access point in a region other
than one of those identified in this field.
Firmware Version The version of the firmware currently installed.
Current Time Displays the current system time of the access point.
Current IP Settings
IP Address The IP address of the wireless access point.
Subnet Mask The subnet mask for IP address of the wireless access point.
Default Gateway The default gateway for the wireless access point communication.
DHCP Client Enabled indicates that the current IP address of the AP was obtained from a
DHCP server on your network. Disabled indicated a static IP configuration.
To Next Page
Loading...
Need help?
General
