NETGEAR XS728T ProSAFE - Page 135

Security
133
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
4. If you make changes to the page, click Apply to apply the changes to the system.
Configuration changes take effect immediately.
The following fields are displayed:
Private VLAN Port Mode Configuration
 To display the Private VLAN Port Mode Configuration page:
1. Click Security > Traffic Control> Private VLAN > Private VLAN Port Mode
Configuration.
2. Use Switch Port Mode to select the Switch Port Mode. The default is 'General'.
• General: Sets port in General Mode. This means that the port is not a private VLAN
port. This is the default configuration.
• Private VLAN Promiscuous: Sets port in Promiscuous Mode. Used for private VLAN
configuration.
• Private VLAN Host: Sets port in Host Mode. Used for Private VLAN configuration.
3. If you make changes to the page, click Apply to apply the changes to the system.
Configuration changes take effect immediately.
The following field is displayed:.
Private VLAN Host Interface Configuration
Use this page to apply Private VLAN Host interface settings on selected device interfaces.
 To display the VLAN Host Interface Configuration page:
1. Click Security > Traffic Control> Private VLAN > Private VLAN Host Interface
Configuration.
2. Use Host Primary VLAN to set the primary VLAN ID for Host Association Mode. The range
of the VLAN ID is 2-4093. The drop-down box lists only primary VLANs.
3. Use Host Secondary VLAN to set the Secondary VLAN ID for Host Association Mode. The
range of the VLAN ID is 2-4093. The configured VLAN ID must be previously configured as
a secondary VLAN.
4. If you make changes to the page, click Apply to apply the changes to the system.
Configuration changes take effect immediately.
Field Description
Isolated VLAN Displays the isolated VLAN associated with the
selected primary VLAN.
Community VLAN(s) Displays the list of community VLAN(s) associated
with the selected primary VLAN.
Field Description
Interface Select the physical or LAG interface for which you
want to display or configure data.