Security
136
XS728T ProSAFE 28-Port 10-Gigabit L2+ Smart Switch
• ACL Based on Destination IPv6. Creates an ACL based on the destination IPv6
prefix and IPv6 prefix length.
• ACL Based on Source IPv6. Creates an ACL based on the source IPv6 prefix and
IPv6 prefix length.
• ACL Based on Destination IPv4 L4 Port. Creates an ACL based on the destination
IPv4 layer 4 port number.
• ACL Based on Source IPv4 L4 Port. Creates an ACL based on the source IPv4
layer 4 port number.
• ACL Based on Destination IPv6 L4 Port. Creates an ACL based on the destination
IPv6 layer 4 port number.
• ACL Based on Source IPv6 L4 Port. Creates an ACL based on the source IPv6
layer 4 port number.
3. Configure the settings in the following table, based on the selection in the ACL Type list:
Note: The Rule ID, Action, and Match Every fields appear for all ACL types.
The remaining two fields vary according to the selected ACL type.
• In the Rule ID field, enter a number that is used to identify the rule. The valid range is
1 - 50.
• In the Action field, specify what action must be taken if a packet matches the rule's
criteria. The choices are Permit or Deny.
• In the Match Every field, specify Enable or Disable.
• In the remaining two fields, specify data according to the table below.
To Next Page
Loading...
