Neuson 6001 - Driving the Dumper; Preheating Start Switch: Overview; Before Starting the Engine; Starting the Engine: General

3-16 BA 6001/9001/10001 En – Edition 2.0 * * 6001b330.fm
Operation
3.5 Driving the dumper
Preheating start switch: overview
Before starting the engine
☞ Adjust your seat position – see Seat adjustment on page 3-25
Important!
All controls must be within easy reach. You must be able to press the accelerator
and brake pedals to their limit positions!
☞ Fasten your seat belt – see Seat belt on page 3-26
• Do not fasten your seat belt if the rollbar is not raised!
☞ Check whether all levers and pedals are in neutral position
☞ Press the accelerator pedal to the centre position (between minimum and maximum) if
the engine is cold
Starting the engine: general
• The starter cannot be actuated if:
• the engine is already running (start repeat interlock).
• the drive lever is not in neutral position,
• the parking brake is not applied.
• Do not run the starter for more than 10 seconds
• Wait about 1 minute so the battery can recover before trying again
1
0
2
3
Fig. 3: Preheating start switch
G
Position
Function Power consumer
0
Insert or remove the ignition key None
1
ON/drive position
All functions are operational
➥ Telltales come on
2
Preheats the engine (10 – 15
seconds)
➥ Until the preheating telltale
goes out
3
Starts the engine
➥ Starter is actuated
➥ Telltales must go out
Operation