BA 6001/9001/10001 En – Edition 2.0 * 6001b330.fm 3-17
Operation
Procedure
After you have completed the starting preparations:
☞ Insert the ignition key in preheating start switch 15
☞ Turn the ignition key to position “1”
☞ Check whether the following telltales come on:
➥ Telltale 8 for engine oil pressure
➥ Telltale 6 for alternator charge function
☞ Replace defective telltales immediately
☞ Turn the ignition key to position “2” and hold it in this position until the preheating telltale
goes out
☞ Turn the ignition key to position “3” and hold it in this position until the engine starts
➥ If the engine does not start after 10 seconds
☞ Interrupt the start procedure and try again after 1 minute
➥ If the engine still does not start after the second try
☞ Contact a Neuson workshop for troubleshooting.
➥ As soon as the engine runs:
☞ Release the ignition key
When the engine runs smoothly (increased engine speed):
In general, a battery delivers less energy in cold conditions. Therefore make sure
the battery is always well charged.
1
0
2
3
Fig. 4: Preheating start switch
15
Fig. 5: Telltales
8
3
To Next Page