MX Series Voice Gateway User Manual
New Rock Technologies, Inc. 23
Figure 1-10 MX60E Front Panel
Table 1-16 Description of MX60E Front Panel
Each interface slot has four RJ45 sockets; each RJ45 socket corresponds with four pairs of analog
lines. CAT-5 cables are used to connect the interface card and distribution panel in equipment
installation. For corresponding relations of RJ45 and RJ11, see 7 Appendix: RJ45 and RJ11
Corresponding Relations.
Note: Numbers of interface slots vary from different configuration. Numbering definition of interface
slots: on the left side of chassis is #1 slot (marked with No.1 to 16), in the middle of chassis is #2 slot
(marked with No.17 to 32), on the right side of chassis is #3 slot (marked with No.33 to 48).
Matrix of 4 x 4 LED status indicators on the interface card. Each column of LED indicator matrix
matches four telephone lines on a RJ45. The first column on the left matches Line 1-4 respectively
from top to bottom, the first column on the right matches Line 13-16 respectively from top to bottom,
and the middle columns in the same manner.