FlLTER-n
Rlter Select
Syntax:
FILTER-n
<filter>
where
n
is
either
A
or
B
Parameters:
The parameter <filter>
is
an integer in the range
0
to
3
inclusive.
0
corre-
sponds to no filtering,
1
to analog filter only,
2
to digital averaging filter only,
and
3
to analog and digital filters combined.
Function:
This command selects a filter combination to be used to condition readings
taken from the detector. The choices are to have no filter at all, an analog
filter, digital averaging filter, and both the analog and digital filters. The digital
filter processes every signal reading by averaging it with the last
9
readings
taken.
All detectors signals are filtered to some extent even without the analog filter
feature. By enabling the analog filter the signal
is
filtered by a
5
Hz
low pass
instead of the standard filter.
If
an attempt
is
made to enable the analog filter for a detector that does not
support
it,
an execution error will occur.
Related Commands: FILTER-n?
FILTER-n?
Fdter Query
Syntax:
FILTER-n?
where
n
is
either
A
or
B
Parameters:
None
Function:
This query returns a value that represents the filter combination currently
being used to condition readings.
Returns:
<filter>
<filter>
is
of type <number> in a range of
0
to
3
with
0
corresponding to no
filter,
1
to analog filter only,
2
to digital averaging filter only, and
3
to analog
and digital filters combined.
Related Commands: FILTER-n
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
