TRIGOUTPOL?
Trigger Out Polarity Query
Syntax:
TRIGOUTPOL?
Parameters:
None
Function:
This query returns a value that indicates whether the trigger out polarity is
active high or active low.
Returns:
<state>
<state>
is
of type <number> and represents the integer
0,
if the polarity is
active low, or
1,
if
the polarity is active high.
Related Commands:
TRIGOUT, TRIGOUT?, TRIGOUTFREQ, TRIGOUTFREQ?,
TRIGOUTLVL, TRIGOUTLVL?, TRIGOUTPOL
UNwn
Units Select
Syntax:
UNITS-n <units>
where n
is
either
A
or
B
Parameters:
<units>
is
of type <string>. All possible values of units are listed below:
"A
specifies amps
"W"
specifies watts
"W/cm" specifies watts/cm2
"dBm" specifies dBm
"dB" specifies dB
"REL" specifies linear ratio
A subset of these units will
be
valid for a particular detector and acquisition mode.
Function:
Sets the units to be used for subsequent measurements. Once the units have
been set, all new readings are given in the new units.
Related Commands:
MODE-n, MODE-n?, UNITS-n?
UNITLn?
Units Query
Syntax:
UNITS-n?
where n
is
either
A
or
B
Parameters:
None
Function:
This query returns the units of readings currently being taken.
Returns:
<units>
<units>
is
of type <string> in the double quote format. The possible values of
units are:
"A,
"W",
"W/cmw, "dBmw, "dB" or
"REL"
depending on the detector
and acquisition mode.
Related Commands:
MODE-n, MODE-n?, UNITS-n
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
