EasyManuals Logo

Newport 2832-C User Manual

Newport 2832-C
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #91 background imageLoading...
Page #91 background image
USRCAL-n
User Calibration Enable
Syntax:
USRCAL-n <state>
where n
is
either A
or
B
Parameters:
The parameter <state>
is
a <number> which can be
0
or
1.
If
the number is
0,
then user calibration
is
disabled.
If
the number
is
1,
then user calibration
is
enabled.
Function:
This command enables or disables the use of a user defined calibration point.
Related Commands: ATTN-n, AlTN-n?, LAMBDA-n, LAMBDA-n?, RESP-n?,
USRCAL-n?, USRRESP-n, USRRESP-n?
USRCAL-n?
User Calibration Enable Query
Syntax:
USRCAL-n?
where
n
is
either A
or
B
Parameters:
None
Function:
This query returns a value showing whether or not user calibration is enabled
or disabled.
Returns: <state>
<state>
is
of type <number> and represents an integer
0,
if
user calibration is
disabled, or
1,
if user calibration
is
enabled.
Related Commands: ATTN-n, AVN-n?, LAMBDA-n, ,LAMBDA-n?, RESP-n?,
USRCAL-n, USRRESP-n, USRRESP-n?
USRREF-n
User Defined Reference Value Select
Syntax:
USRREF-n
<vab
where
n
is
either A
or
B
Pararne ters:
The parameter <val>
is
of type <number>.
Function:
This command provides a means of directly storing a reference value to be
used in linear and logarithmic (dB) relative measurements. The units
of
this
value are Watts.
Related Commands: REFSEL-n, REFSEL-n?. STOREF-n, USRREF-n?
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Newport 2832-C and is the answer not in the manual?

Newport 2832-C Specifications

General IconGeneral
BrandNewport
Model2832-C
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals