Page | 85
Eject – Dismount one of the storage volumes in 3Play’s hot-swap drive bays (or another
external volume) preparatory to disconnection or removal.
Exit – Leave the Replay Desktop and return to the Session screen.
OPTIONS
One Button Marking – Section 8.10.1 discusses methods you will use to mark (define the
in and out points for) CLIP LIST events. The “one button marking” method requires only
that you press the OUT button; an In point is set automatically at a pre-defined earlier
time. This menu items lets you choose the offset used for the automatic In point.
Still Image Duration – Choose the default duration applied to still images added to the
CLIP or PLAY LIST.
Out Point Padding – This menu item optionally allows play to continue past the actual
Out point for CLIP LIST events from a minimum period of five seconds to ‘infinite’ (i.e.,
until the recorded file ends or you press STOP).
CLIP LIST Previews – This option toggles the display of Clip Monitors in the area below
the CLIPS LIST tabs. These small previews show all recorded angles for the currently
active CLIP LIST event row.
Failsafe Camera Configuration – If you have enabled A/V Passthrough (See Section
7.1.3) you can use this menu item to access setup controls for (video) Input 8 when the
session is in Redundant (4 Channel Mode).
Tally from TriCaster – When a downstream TriCaster is receiving 3Play’s network output
via one of its own Network Inputs, enable this option to shown red and green on-air
tally borders around 3Play viewports.
Single Pane View – This powerful option can have a dramatic impact on your replay
workflow:
o Enable Single Pane View to collapse the CLIPS LIST and PLAY LIST panes into one
‘super’ module showing CLIPS LIST tabs at left, and PLAY LIST tabs at right.
To Next Page
Loading...
