Doc# E107706 6 - 7
6: Using the External Displays
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
• Use the MODE button to scroll between modes.
• Use the UP/DOWN arrows to scroll from group to group within each mode.
• Use the LEFT/RIGHT arrows to scroll from reading to reading within each group.
Use the Communicator EXT
TM
software to Flash Update the P40N/P40N+ external
display. Refer to the Communicator EXT
TM
4.0 and MeterManager EXT User Manual for
instructions.
6.3: Dynamic Readings Mode
The External Display puts itself in the Dynamic Readings Mode upon power-up. Use
the Mode button to access the Dynamic Readings from other Modes. Use the Up/Down
arrows to navigate from Group to Group within this Mode. See Section 6.4 for a Navi-
gation map of the Dynamic Readings Mode.
Group 1: Phase to Neutral Voltages (Use the Left/Right arrows to access the fol-
lowing readings, in order.)
• Volts AN/BN/CN
• Maximum Volts AN/BN/CN
• Minimum Volts AN/BN/CN
• Volts AN/BN/CN %THD
• Volts AN/BN/CN Maximum %THD
• Volts AN/BN/CN Minimum %THD
Group 2: Phase to Phase Voltages (Use the Left/Right arrows to access the follow-
ing readings, in order.)
• Volts AB/BC/CA
• Minimum Volts AB/BC/CA
• Maximum Volts AB/BC/CA
To Next Page
Loading...
