Doc# E107706 6 - 14
6: Using the External Displays
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
6.7: Display Features Mode
Use the Mode button to access the Display Features Mode from other modes. Use the
Up/Down arrows to navigate from group to group within this mode. See Section 6.8
for a Navigation map of the Display Features mode.
Group 1: Reset Max/Min
Press Enter to reset the Max and Min values.
NOTE: If the Password Protection feature has been enabled through Communicator
EXT software, you will need to enter a password to reset the Max/Min readings. Follow
this procedure:
1. Press Enter.
2. Enter the password, one character at a time, by pressing the Up or Down arrows.
(Each password character begins as an "A". Press the Up arrow to increment the
character from "A-Z" and then from "0-9". Press the Down arrow to decrement the
character from "A" to "9-0" and then from "Z-A".)
3. Press Set to enter each character in the password.
4. When the entire password is shown on the Display screen, press Enter.
5. Once the password is entered correctly, press Enter again to reset the Max/Min
values.
Group 2: Reset Energy
Press Enter to reset the Energy readings.
NOTE: If the Password Protection feature has been enabled through Communicator
EXT
TM
software, you will need to enter a password to reset the Energy readings. Fol-
low steps 1-4, above. Then press Enter again to reset energy.
Group 3: Display Baud Rate/Address
Group 4: Display Communication Protocol
Group 7: Lamp Test
To Next Page
Loading...
