Doc# E107706 2 - 6
2: Meter Overview
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
2.5.4: Network Settings
Configure the Network Settings using the following steps (refer to the Communicator
EXT
TM
4.0 and MeterManager EXT Software User Manual for more details).
1. From the Communicator EXT
TM
application‘s Main screen, click Profile to open the
Device Profile screen.
2. From the Device Profile screen, double-click on the Communications Ports line,
then double-click on any of the ports. The Communications Settings screen opens.
3. If you are going to use DHCP, click the Advanced Settings button and follow these
steps:
a. Click the DHCP tab at the top of the Advanced Settings screen.
b. Click Enable. DHCP automatically enters the IP Address and some or all of the
Interface Settings.
c. Click OK at the bottom of the screen to return to the Communication Setting
screen. You may have to manually enter DNS, Email, Gateway Setting and/or a
unique computer name. Consult your Network Administrator if you are not sure
of the correct information to enter.
d. Click OK.
4. If you are not using DHCP, enter the following information in the Network Settings
section of the Communication Settings screen (consult your system administrator if
you are not sure of the information to enter):
• IP Address: For example:10.0.0.1
• Subnet Mask: For example: 255.255.255.0
• Default Gateway: For example: 0.0.0.0
• Computer Name: For example: NETWORK
5. Enter the Domain Name Server and Computer Name.
To Next Page
Loading...
