Doc# E107706 5 - 12
5: Communication Wiring
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
As the table above shows, all I/O modules are shipped pre-programmed with a baud
rate of 57600 and addresses. For programming instructions, refer to Chapter 14 in
the Communicator EXT
TM
4.0 and MeterManager EXT Software User Manual.
See the next page for the external displays’ VA Ratings.
NOTE: For 24 or 48 VDC applications, EIG recommends the PB1 power supply.
Example order number: PB1-D-12VO (PB1)
If you are using a PSIO (for 125V AC/DC input) or PB1 your maximum VA is 12.
Table 1:
I/O Module Factory Settings and VA Ratings
Model# Module Address VA Rating
1mAON4 0-1mA, 4 Analog
Outputs
128 2.7VA
1mAON8 0-1mA, 8 Analog
Outputs
128 3.2VA
20mAON4 4-20mA, 4 Analog
Outputs
132 5.0VA
20mAON8 4-20mA, 8 Analog
Outputs
132 8.5VA
8AI1 0-1mA, 8 Analog
Inputs
136 2.3VA
8AI2 0-20mA, 8 Analog
Inputs
140 2.3VA
8AI3 0-5VDC, 8 Analog
Inputs
144 2.3VA
8AI4 0-10VDC, 8 Analog
Inputs
148 2.3VA
4RO1 4 Latching Relay
Outputs
156 2.7VA
4PO1 4 KYZ Pulse Outputs 160 2.7VA
8DI1 8 Status Inputs
(Wet/Dry)
164 1.0VA
To Next Page
Loading...
