Nilfisk-Advance SC2000 - Removal and Installation; Drive Pedal Potentiometer Disassembly;Assembly

Wheels, Drive System 101Service Manual – SC2000
Removal and Installation
Drive Pedal Potentiometer Disassembly/Assembly
Disassembly
1. Drive the machine on a level oor or on a hoisting system to facilitate the disassembly procedures.
2. Remove the operator key and disconnect the red battery connector
3. Lift the machine as shown (A, Figure 4).
4. Remove the 2 screws (B) and disassemble the accelerator pedal (C).
5. Under the machine disconnect the connection (D) of the drive pedal potentiometer (E).
6. Remove the 3 screws (F), then disassemble the drive pedal potentiometer (E).
Figure 4
C
F
A
B
E
E
D
Assembly
7. Assemble the components in the reverse order of disassembly.