Electrical System 49Service Manual – SC2000
Troubleshooting
See the other chapters for previously provided instructions for other electrical system components.
Trouble Possible Causes Remedy
The machine is not working Batteries (BAT) at or connections faulty Charge the battery or clean the
connections
The batteries (BAT) are broken Check the battery no-load voltage
The battery charger (CH) is broken Replace
The wiring harness is cut or pressed or short circuited Repair
The key electronic board (EB3) is broken Replace
Note: Adamagetothebatterychargeroritsconnectionscanpreventthemachinefrom
operatingproperly.
To Next Page
Loading...
