Squeegee System 93Service Manual – SC2000
Squeegee Tie Rod Disassembly/Assembly
Disassembly
1. Drive the machine on a level oor or on a hoisting system to facilitate the disassembly procedures.
2. Lower the squeegee.
3. Ensure that the machine is off and the operator key has been removed.
4. Unscrew the nuts (A, Figure 5), retrieve the washers and spacers.
5. Carefully disassemble the tie rod (B) from the studs, by paying attention to the squeegee reset spring
(C).
Assembly
6. Assemble the components in the reverse order of disassembly, and note the following:
◦ Assemble the tie rod (B) by loading it with the squeegee reset spring (C).
Figure 5
A
B
C
A
To Next Page
Loading...
