Squeegee System 92Service Manual – SC2000
Removal and Installation
Squeegee Lifting Actuator Disassembly/Assembly
Disassembly
1. Drive the machine on a level oor.
2. Lower the squeegee.
3. Ensure that the machine is off and the operator key has been removed.
4. Disassemble the retaining spring (A, Figure 4), retrieve screws and washers.
5. Disconnect the squeegee power supply connection (B).
6. Remove the two screws (C) and the screw (D), then lift the actuator plate (E).
7. Remove the nut (F) and retrieve the screw (G).
8. Replace the actuator (H).
Assembly
9. Assemble the components in the reverse order of disassembly.
Figure 4
G
F
H
B
B
E
D
A
To Next Page
Loading...
