Nilfisk-Advance SC2000 - Troubleshooting Guide; Motor and Movement Issues; Brush and Brush Operation Issues; Alarm Message Interpretation

Solution System 85Service Manual – SC2000
Water Level Sensor Disassembly/Assembly
1. Drive the machine on a level oor.
2. Switch off the machine and disconnect the battery connector.
3. Lift the recovery tank assembly and the driver’s seat, then disassemble the electronic component
compartment cover.
4. Unscrew the screw (A, Figure 11) and remove the sensor holder (B).
5. Unscrew the two screws (C) and remove the water level sensor (D).
Assembly
6. Assemble the components in the reverse order of disassembly.
Figure 11
C
D
A
B