Nilfisk-Advance SC2000 - Control Panel Functions; Control Panel Layout and Buttons; Multifunction Display Guide

Scrub System, Disc 66Service Manual – SC2000
Troubleshooting
Trouble Possible Causes Remedy
The brush does not clean properly The brush is excessively worn Replace
One brush does not turn See the chapter Control System,
Function Electronic Board (EB1)
Error Codes
Brush motor carbon brushes worn Replace
Presence of bulky debris or string around the brush or
between the brush and attachment ange
Remove the brush and clean it
Faulty brush motor Repair or replace
Wiring damaged Repair
It is not possible to lift/lower the brush See the chapter Control System,
Function Electronic Board (EB1)
Error Codes
Deck lifting/lowering actuator (M5) broken Replace
Break in actuator wiring Check the connections according
to the instructions in the Electrical
System chapter, Troubleshooting
paragraph
Function electronic board (EB1) damaged Replace
The brush disengagement system does
not work
Function electronic board (EB1) faulty Replace