Control System 33Service Manual – SC2000
Function Electronic Board (EB1) Removal/Replacement (Continues)
8. Disconnect the following connections sequentially (Figure 13):
◦ (I) Key, accelerator and steering wheel electronic board connection (J1).
◦ (J) Squeegee actuator, beacon light and driver’s seat sensor connection (J3).
◦ (K) Battery charger connection (J4).
◦ (L) Brush deck actuator connection (J2).
◦ (M) Accessory connection (J8).
Figure 13
II KK LL MM JJ
9. Unscrew the 4 retaining screws (N) and carefully remove the function electronic board (Figure 14).
Figure 14
N
N
N
N
N
N
N
N
10. Assemble the components in the reverse order of disassembly.
To Next Page
Loading...
