Nilfisk-Advance SC2000 Service Manual

Electrical System 47Service Manual – SC2000
Battery Charging (Continues)
Warning! When using lead (WET) batteries, battery charging produces highly explosive
hydrogen gas. Charge the batteries in well-ventilated areas and away from naked
ames. Do not smoke while charging the batteries. Keep the recovery tank lifted until
the battery charging cycle is over.
Warning! Pay close attention when charging WET CELL batteries, as there may be battery uid
leakages. The battery uid is corrosive. If it comes in contact with skin or eyes, rinse
thoroughly with water and consult a physician.
1. (For WET CELL batteries only) Check the level of electrolyte inside the batteries. If necessary, unscrew
the caps and top up.
2. When the correct level is restored, close the caps and clean the tops of the batteries.
Charging the Batteries with an External Battery
Charger
3. Check that the external battery charger is
suitable by referring to the relevant Manual.
The battery charger voltage rating must be 24V.
4. Press the emergency push-button, disconnect
the red battery connector and connect it to the
external battery charger.
5. Connect the battery charger to the electrical
mains.
6. After charging, disconnect the battery charger
from the electrical mains and from the battery
red connector.
7. Connect the battery connector to the machine.
8. Disengage the support rod, then grasp the
handle and carefully lower the recovery tank
assembly.
Battery charging with battery charger installed on
the machine
9. Plug the battery charger into the electrical
mains (the mains voltage and frequency must
be compatible with the battery charger values
shown on the machine serial number plate).
Note: Whenthebatterychargeris
connectedtotheelectrical
mains,allmachinefunctions
areautomaticallycutoff.
10. Whentherstorsecondsegmentfromtheleftin
thebatterysymbolisashing,thismeansthat
the battery charger is charging the batteries.
11. When the third segment from the left in the
batterysymbolisashing,thismeansthatthe
batterychargerisnishingthebatterycharging
cycle.
12. When all segments of the battery symbol
are steadily lit, the battery charging cycle is
complete.
13. Disconnect the battery charger plug from the
electrical mains and place it in its holder.
14. Disengage the support rod, then grasp the
handle and carefully lower the recovery tank
assembly.
Note: Forfurtherinformationabout
theoperationofthebattery
charger,seetherelevant
Manual.

Nilfisk-Advance SC2000 Specifications

General

Brand	Nilfisk-Advance
Model	SC2000
Category	Floor Machine
Language	English