32
NITTY GRITTY.IT
make it shine
CLINOX PRO • AIR • POWER • SURFACE
USER MANUAL
6. CLEANING AND POLISHING OF WELDS
6.1.
Before starting to pickle / polish a piece of stainless steel, check that all the preliminary operations described in chapter 5 have
been carried out correctly.
For its normal operation, the appliance requires the use of special electrolyte solutions called BOMAR.
It is very important to choose the most appropriate liquid for the type of processing to be carried out:
• BRILL BOMAR, suitable for both pickling and polishing.
• STANDARD BOMAR, suitable only for pickling.
• TIG BOMAR, suitable only for pickling.
• NEUTRAL BOMAR, suitable only for pickling.
Always refer to the product data sheet for detailed indications regarding its eld of use.
N
ITTY-GRITTY Customer Service (info@nitty-gritty.it) is available for any additional information.
Acid solutions are dangerous and can cause damage to people and property: please read carefully the chapter
1 on the safety regulations and personal protective equipment that must be used when working with these
substances.
• Make sure that the desired electrolyte solution type is in the tank and that the quantity is adequate for the type of processing
you are about to start; if necessary, top up the tank.
• Make sure the most appropriate accessory is installed on the torch for the type of processing to be performed.
• Turn on the device by turning the main switch (located on the back of the unit) to the "I" position.
• Select the desired operating mode by pressing the MODE button on the control panel (see chapter 3.3 for more information).
• Press the SET button to select the desired power level (see chapter 3.4 for more information).
In order not to cause excessive wear or damage to the accessories, it is recommended that you select the power level
according to the following table, which takes into account both the power supplied by the x2 line device model used, and
the conductivity of the electrolyte solution.
ACCESSORY x2 LINE
BRILL
BOMAR
STANDARD
BOMAR
TIG
BOMAR
NEUTRAL
BOMAR
Hooded "Tig Bond" felt
PRO/AIR - - LOW LOW
POWER - - LOW LOW
SURFACE - - - -
"Fast Bond" felt
PRO/AIR HIGH HIGH HIGH HIGH
POWER MID MID HIGH HIGH
SURFACE LOW LOW MID MID
Felt 45 mm
PRO/AIR HIGH HIGH HIGH HIGH
POWER MID MID HIGH HIGH
SURFACE LOW LOW MID MID
Felt 100 mm
PRO/AIR - - - -
POWER - - - -
SURFACE MID MID HIGH HIGH
Brush M, L, L at
PRO/AIR HIGH HIGH HIGH HIGH
POWER MID MID MID MID
SURFACE LOW LOW LOW LOW
Brush XL
PRO/AIR NO NO NO NO
POWER HIGH HIGH HIGH HIGH
SURFACE HIGH HIGH HIGH HIGH
The table is to be considered valid only if the manufacturer's predened voltage values are used in the various operating
modes.
To Next Page
Loading...