46
NITTY GRITTY.IT
make it shine
CLINOX PRO • AIR • POWER • SURFACE
USER MANUAL
7.11.
• Turn o the device by turning the main switch to the "O" position.
• Disconnect the appliance plug from the power supply socket.
• Carry out routine maintenance on the device as described in chapter 10.1.
• To limit any environmental impact, used felt and used liquids must always be disposed of in accordance with current waste
disposal regulations (see chapter 11 for additional information).
• Disconnect the earth cable crocodile clip from the machined part.
• Use the INOX FIT solution on the treated piece.
• Rub the surface with a microbre cloth dampened with
clean water.
• Dry the surface using a dry microbre cloth.
It is very important to spray the INOX FIT
solution on the workpiece; this product
neutralises any BOMAR residue, thus avoiding
the formation of halos and white spots (which
can only be eliminated by repeating the entire
process).
Alternatively, it is possible to clean the surface
with an abundant jet of water.
To Next Page
Loading...