41
line
A
B
C
CLINOX PRO • AIR • POWER • SURFACE
USER MANUAL
7.7.
For its normal operation, the appliance requires the use of particular acid solutions that can be dangerous (read
chapter 1 carefully).
When replacing an accessory on the torch, be very careful of any electrolyte residues remaining on the felt
pad or brush.
To reduce the risk of direct skin contact with acid solutions, always wear suitable protective gloves when mounting
the electrolyte tube on the manual torch.
• Unscrew the tube cap (A).
Keep the cap so that you can close the tube if it is replaced
before it is completely empty.
• If the tube is new, remove the sealing tab (B).
• Screw the tube into the special coupling of the manual
torch (C), remembering to keep it facing upwards to avoid
leakage of liquid.
• Before gripping the torch and starting processing, make
sure that the tube is correctly screwed onto the coupling
and that there is no leakage of liquid.
When installing the tube, always keep it in an
upright position with the cap facing upwards
to avoid unwanted spillage of electrolyte
solution.
To Next Page
Loading...