50
NITTY GRITTY.IT
make it shine
CLINOX PRO • AIR • POWER • SURFACE
USER MANUAL
It is important to keep the electrodes always
well wet to prevent them from overheating.
8.6.
• Before starting to pickle / polish a piece of stainless steel, check that all the preliminary operations described in chapter 5
have been carried out correctly.
• Make sure the most appropriate accessory is installed on the torch for the type of processing to be performed.
• Choose the most appropriate liquid for the type of processing to be carried out:
◊ BRILL BOMAR, suitable for both pickling and polishing.
◊ STANDARD BOMAR, suitable only for pickling.
◊ TIG BOMAR, suitable only for pickling.
◊ NEUTRAL BOMAR, suitable only for pickling.
Always refer to the product data sheet for detailed indications regarding its eld of use.
N
ITTY-GRITTY Customer Service (info@nitty-gritty.it) is available for any additional information.
Acid solutions are dangerous and can cause
damage to people and property: please read
carefully the chapter 1 on the safety regulations
and personal protective equipment that must
be used when working with these substances.
• Pour the electrolyte solution into a jar or plastic container
large enough to hold the insert or brush.
• Fully immerse the insert with felt or brush in the container.
• Turn on the device by turning the main switch (located on the back of the unit) to the "I" position.
• Select the desired operating mode by pressing the MODE button on the control panel (see chapter 3.3 for more information).
• Press the SET button to select the desired power level (see chapter 3.4 for more information).
In order not to cause excessive wear or damage to the accessories, it is recommended that you select the power level
according to the following table, which takes into account both the power supplied by the x2 line device model used, and
the conductivity of the electrolyte solution.
To Next Page
Loading...