9
line
CLINOX PRO • AIR • POWER • SURFACE
USER MANUAL
ELECTRIC SHOCKS
All electric shocks are potentially fatal, so it is necessary
to take appropriate safety measures to minimise the risk of
electric shock:
• Do not use the device in damp rooms.
• Never touch live parts.
• The device must be connected to a mains power
supply tted with an ecient, functioning and
periodically tested earthing system. Otherwise, the
manufacturer is relieved of any liability for any loss
or damage caused by this serious act of negligence.
• Always switch o the device if the workstation remains
unattended (during breaks and at the end of shifts).
• Frequently inspect the power supply cable and if there is
any damage or abrasion to the protective coating, replace
it immediately.
• Carry out maintenance only after disconnecting the
device from the mains.
• Maintenance of electrical parts must only be performed by
experienced and authorised personnel.
• Always use original spare parts.
If while using the device you experience even the slightest
sensation of electric shock, switch o the appliance
immediately and do not use it until the problem has been
identied and resolved by qualied personnel.
BURN PREVENTION
During the operation of the device, the workpieces and some
of the torch components can reach high temperatures.
• Very hot parts can cause skin burns upon contact.
Be very careful when handling a newly processed piece
and when removing the felts and inserts.
All users of the appliance must wear suitable protective
gloves for the handling of the parts and for the use of the
torch.
All users and maintainers of the device must wear insulating
gloves to protect themselves from accidental contact with
live parts.
To maximise safety, it is preferable to always use insulating
tools when performing maintenance operations.
To Next Page
Loading...