7 Troubleshooting
104 IP390, 105i & 105s Security Platform Installation Guide
Note
Adding a question mark (?) after any command provides additional
command options. Typing a question mark (?) at a prompt provides a list
of available commands.
hostname[admin]# iclid
hostname | IP address>
hostname | IP address> ?
exit get help quit show
hostname | IP address>
hostname | IP address> show ?
addressbgpigmpiphelpermfcripvrrp bootpgwigrpkrtospf
route inbound-filterdvmrpinterface memory
resource version
hostname | IP address> show route ?
aggregate bgp igrp ospf static
all direct inactive rip summary
hostname | IP address> show route ospf
Codes: C - connected, S - static, I - IGRP, R - RIP,
B - BGP, O - OSPF, E - OSPF external, A - Aggregate,
K - Kernel Remnant, H - Hidden, S - Suppressed
The response to the preceding ICLID command is as follows:
0 172.16/16 via 10.1.1.225, eith-sp4p1c0,cost 3, age 3111
In addition, several trace options are available. You can enable these options
under the routing options in Network Voyager. When a trace is enabled the
output appears in
/var/tmp/ipsrd.log.
Common Problems with OSPF
Use tcpdump to view routing information. Use the following command
display routing updates for that interface:
tcpdump -i
interface
proto ospf
To Next Page
Loading...