3 Performing the Initial Configuration
42 IP390, 105i & 105s Security Platform Installation Guide
Using a Console Connection
If you have not already done so, you need to connect to the console port to
complete the initial configuration. For information about console connections,
see “Connecting to the Console or Auxiliary Port” on page 32.
Before you perform the initial configuration, you might gather the following
information, which can be useful during the configuration process:
What is the hostname?
What is the admin password?
Will you use Nokia Network Voyager for subsequent configuration?
Which interface will you use?
What is the assigned IP address and masklength?
What is the default router?
What is the interface speed?
Note
The default interface speed for the appliance is 1000 Mbps.
You can make VLAN, SNMP community string, and remote logging
configuration choices at this time, although you can change them later.
To perform the initial configuration
1. Press the power switch to the “on” position to turn on power to the
appliance.
00527
Power switchCooling fans
To Next Page
Loading...