Using Nokia Network Voyager
IP390, 105i & 105s Security Platform Installation Guide 45
Using Nokia Network Voyager
Use Nokia Network Voyager to configure and monitor your appliance. For
additional information about how to use Network Voyager, see “Viewing
Nokia IPSO Documentation by Using Nokia Network Voyager” later in this
section.
To open Nokia Network Voyager
1. Open a Web browser on the host you plan to use to configure or monitor
your appliance.
2. In the Location or Address field, enter the IP address of the initial
interface you configured for the appliance.
You are prompted to enter the admin username and the password you
entered when you performed the initial configuration.
Note
If the username login screen does not open, you might not have a
physical network connection between the host and your appliance, or
you might have a network routing problem. Confirm the information
you entered during the initial configuration and check that all cables
are firmly connected. For more information, see the troubleshooting
section in the installation guide for your appliance.
To Next Page
Loading...