Four-Port 10/100 Mbps Ethernet NICs
IP390, 105i & 105s Security Platform Installation Guide 63
Ethernet NIC Connectors and Cables
The connectors on the Ethernet NIC are RJ-45 connectors:
To connect to a 10-Mbps or 100-Mbps hub, use a straight-through RJ-45
cable.
To connect directly to a host, use an RJ-45 crossover cable.
Use IEEE 802.3 10BASE-T, 100BASE-TX unshielded twisted-pair,
full-duplex or half-duplex cable.
Caution
Cables that connect to the Ethernet card must be IEEE 802.3
compliant to prevent potential data loss.
You can order appropriate adapter cables separately. You can order additional
cables from a cable vendor of your choice.
Figure 11 shows the pin assignments for the cable. The RJ-45 cable output
connector is numbered from right to left, with the copper tabs facing up and
toward you.
To Next Page
Loading...