IP390, 105i & 105s Security Platform Installation Guide 61
5 Connecting PMC Network
Interface Cards
This chapter describes the PMC network interface cards (NICs) available for
the IP390 appliance and describes how to connect those NICs to your
network. The following NICs are covered:
Four-Port 10/100 Mbps Ethernet NICs
Two-Port Copper Gigabit Ethernet Network Interface Card
Two-Port Fiber-Optic Gigabit Ethernet Network Interface Card
For instructions on adding or replacing interface cards, see Chapter 4,
“Installing and Replacing Network Interface Cards.”
Caution
Protect your
appliance and other electronic equipment from
electrostatic discharge (ESD) damage by making sure you are
properly grounded before you touch any electronic component.
Four-Port 10/100 Mbps Ethernet NICs
The IP390 appliance supports Nokia-approved, four-port UTP5 dual-mode
10-Mbps and 100-Mbps Ethernet NICs.
To Next Page
Loading...