5 Connecting PMC Network Interface Cards
66 IP390, 105i & 105s Security Platform Installation Guide
Packet tracing for analysis through tcpdump
Compliance with IEEE 802.3ab Gigabit Ethernet specification
Figure 14 shows the front panel details for the two-port copper Gigabit
Ethernet NIC you use in the Nokia IP390 appliance.
Figure 14 Two-Port Copper Gigabit Ethernet NIC
Copper Gigabit Ethernet Connectors and Cables
The copper Gigabit Ethernet NIC receptacles use RJ-45 connectors.
To connect to a 1 Gbps hub, switch, or router, use a straight-through RJ-45
cable (Cat 5 type cable, or as required by your network configuration).
Note
All Nokia copper Gigabit Ethernet NICs support cable auto-sensing. You
can use a straight-through or crossover cable to connect the NIC to a
Gigabit Ethernet hub or switch, or to connect directly to a host.
In Figure 15, the RJ-45 cable output connector is numbered from right to left,
with the copper pins facing up and toward you.
00386.5
LINK
ACT
V2
LINK
ACT
1000BaseT
Link LED (solid yellow for 10/100 Mbps, solid green for 1000 Mbps)
Activity LEDs (blinking yellow)
RJ-45 connectors
To Next Page
Loading...