Nokia EM7500 - Page 107

To Next Page

To Previous Page

Troubleshooting Routing Problems

IP390, 105i & 105s Security Platform Installation Guide 107

Problem Routing protocol is not functioning properly.

Solution to ensure that each routing protocol is functioning properly, see

“Common Problems with OSPF” on page 104 and “Common Problems with

RIP” on page 105.

All manuals and user guides at all-guides.com

Main Page

Table of Contents5
About this Guide13
In this Guide13
Conventions this Guide Uses14
Notices14
Command-Line Conventions15
Table 1 Command-Line Conventions15
Text Conventions17
Table 2 Text Conventions17
Related Documentation18
Overview19
About the Nokia Appliance20
Table 3 Specifications for the IP390 Platform20
Figure 1 Component Locations Front View20
Built-In Gigabit Ethernet Ports21
Figure 2 Component Locations Rear View21
Figure 3 Built-In Gigabit Ethernet Ports Details21
PMC Expansion Slots22
Table 4 PMC Network Interface Card Slots22
System Status Leds23
Table 5 System Status Leds23
Figure 4 Appliance Status Leds23
Managing the Appliance24
Logging Options25
Using Hard-Disk Drives for Logging25
Using a Flash-Memory PC Card for Logging25
Figure 5 Location of the PCMCIA Card Slot25
Site Requirements, Warnings, and Cautions26
Software Requirements27
Product Disposal27
Installing the Nokia IP390 Appliance29
Before You Begin29
Rack Mounting the Appliance30
Figure 6 Mounting Screws Location30
Connecting Power31
Figure 7 Adjustable Mounting Brackets31
Connecting to the Console or Auxiliary Port32
Figure 8 Back Panel Power Switch and Socket32
Console Port36
Table 6 Pin Assignments for Console Connector and Cable36
Auxiliary Port37
Table 7 Pin Assignments for AUX Connector and Modem Cable37
Connecting to Network Interfaces38
Performing the Initial Configuration41
Using a Console Connection42
Using Nokia Network Voyager45
Viewing Nokia IPSO Documentation by Using Nokia Network46
Voyager46
Using the Command-Line Interface47
Figure 9 Nokia Network Voyager Reference Access Points47
Using Nokia Horizon Manager49
Installing and Replacing Network Interface Cards51
Deactivating Configured Interfaces52
Removing, Installing, and Replacing Nics52
Before You Start53
Configuring and Activating Interfaces59
Monitoring Network Interface Cards59
Connecting PMC Network Interface Cards61
Four-Port 10/100 Mbps Ethernet Nics61
Ethernet NIC Features62
Figure 10 Four-Port Ethernet NIC Front Panel Details62
Ethernet NIC Connectors and Cables63
Figure 11 Output Connector for the Ethernet Cable64
Figure 12 Ethernet Crossover-Cable Pin Connections64
Two-Port Copper Gigabit Ethernet Network Interface Card65
Copper Gigabit Ethernet NIC Features65
Figure 13 Gigabit Ethernet Crossover Cable Pin Connections65
Copper Gigabit Ethernet Connectors and Cables66
Figure 14 Two-Port Copper Gigabit Ethernet NIC66
Figure 15 Copper Gigabit Ethernet Cable Connector Output Pin67
Figure 16 Gigabit Ethernet Crossover Cable Pin Connections67
Two-Port Fiber-Optic Gigabit Ethernet Network Interface Card68
Fiber-Optic Gigabit Ethernet NIC Features68
Fiber-Optic Gigabit Ethernet Connectors and Cables69
Figure 17 Two-Port Fiber-Optic Gigabit Ethernet NIC69
Installing and Replacing Other Components71
Replacing the Compact Flash Memory Card72
Figure 18 Compact Flash Memory Card Slot73
Installing a Flash-Memory PC Card76
Before You Begin76
Transferring Files with the Flash-Memory PC Card77
Installing or Replacing a Hard-Disk Drive78
Before You Start79
Figure 19 Hard-Disk Drive Location79
Configuring a PC Card or Hard-Disk Drive for Logging84
Replacing or Upgrading Memory86
Before You Start87
Figure 20 DIMM Socket Locations87
Troubleshooting93
General Troubleshooting Information93
Troubleshooting Routing Problems103
A Technical Specifications109
Physical Dimensions109
Space Requirements109
Operating Temperature110
NIC Interfaces110
B Compliance Information111
Declaration of Conformity111
Compliance Statements113
FCC Notice (US)114
Index115

Nokia EM7500 - Page 107

Table of Contents

Related product manuals