Replacing or Upgrading Memory
IP390, 105i & 105s Security Platform Installation Guide 91
6. Slide the chassis tray assembly back into the appliance until it clicks into
place.
The appliance automatically restarts when the chassis tray assembly
clicks into place.
7. Resecure the two retaining screws.
The appliance automatically recognizes the new memory configuration. You
can verify this from the Network Voyager, the CLI, or the IPSO shell.
To verify the memory from the CLI, enter:
show asset hardware
To verify the memory from the IPSO shell, enter:
dmesg | grep ‘real memory’
00538
IP390
00525
IP390
Chassis tray assembly retaining screws
To Next Page
Loading...