Nokia ONT XS-2426X-A - Table 8-13 WAN Parameters; Figure 8-16 WAN Page

2
Configure the following parameters:
Table 8-13 WAN parameters
Field Description
WAN connection list Select a WAN connection from the list to set the connection parameters.
Enabled Tap the Enable / Disable toggle to enable or disable the WAN connection.
Connection type: IPoE
or PPPoE.
Connection mode Select the connection mode of the WAN connection:
• Route mode
• Bridge mode
IP mode Select an IP mode from the list: IPv4 or IPv6.
Enable Click to enable the WAN connection.
NAT Select this checkbox to enable NAT.
Service Enable/disable the following service types for this connection as required.
• VOIP
• TR-069
• INTERNET
• IPTV
Enable VLAN Tap the Enable/disable toggle enable VLAN.
Figure 8-16 WAN page
Configure a XS-2426X-A indoor ONT
Network configuration
Configuring WAN
Nokia ONT
Review Review
December 2021
Issue 1 103
© 2021 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-49546-AAAA-TCZZA