You can:
• Click Delete to delete a particular local device connection.
• You can click
to update the displayed information.
END OF STEPS
8.14 Viewing optics module status
1
Click Status→Optics Module Status from the left pane. The Optics Module Status page
displays the following information.
Table 8-9 Optics Module Status parameters
Field Description
Laser Bias Current (ONT ANI-ONT-Side Optical Measurements) Laser bias current, measured in uA
Optics Module Voltage (ONT ANI-ONT-Side Optical Measurements) Optics module voltage, measured in V
Optics Module Temperature (ONT ANI-ONT-Side Optical Measurements) Optics module temperature, measured in C
Rx Optics Signal Level at 1490 nm (ONT ANI-ONT-Side Optical
Measurements)
Received optics signal level at 1577 nm, measured in
dBm
Tx Optics Signal Level at 1310 nm (ONT ANI-ONT-Side Optical
Measurements)
Transmitted optics signal level at 1270 nm, measured in
dBm
Lower (ONT ANI-ONT-Side Optical Measurements-Optical Threshold) Lower optical threshold, measured in dBm
Upper (ONT ANI-ONT-Side Optical Measurements-Optical Threshold) Upper optical threshold, measured in dBm
Figure 8-9 Optics Module Status page
Configure a XS-2426X-A indoor ONT
Viewing device information and connection status
Viewing optics module status
Nokia ONT
Review Review
© 2021 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-49546-AAAA-TCZZA
December 2021
94 Issue 1
To Next Page
Loading...
