4.2 Safety standards compliance
This section describes the ONT compliance with North American safety standards.
WARNING
Equipment Damage
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
4.2.1 EMC, EMI, and ESD standards compliance
The ONT equipment complies with the following requirements:
• Federal Communications Commission (FCC) CFR 47, Part 15, Subpart B, Class A requirements
for OLT equipment
• GR-1089-CORE requirements, including:
− Section 3 Electromagnetic Interference, Emissions Radiated and Conducted
− Section 3 Immunity, Radiated and Conducted
− Section 2 ESD Discharge Immunity: System Level Electrostatic Discharge and EFT Immunity:
Electrically Fast Transients
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
Figure 4-1 Sample safety label on the ONT equipment
18533
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003. Cet appareil
numerique de la class A est conforme a la norme NMB-003 du Canada
Tested to Comply
with FCC Standards
FOR HOME OR OFFICE USE
COMMUNICATION SERVICE EQUIPMENT
US LISTED
27FY
Type 3R Enclosure - Rainproof
CAUTION
This Assembly Contains Electrostatic Sensitive Devices
c
®
ANSI ONT safety guidelines
Safety standards compliance
Nokia ONT
Review Review
December 2021
Issue 1 35
© 2021 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-49546-AAAA-TCZZA
To Next Page
Loading...
