Table 5-5 XS-2426X-A indoor ONT physical connections
Connection
1
Print Letters Description
POTS port TEL1 and TEL2 This connection is provided through an RJ-11 port. One POTS connection is supported.The
POTS port supports voice services.
Ethernet ports LAN1 to LAN4 This connection is provided through Ethernet RJ-45 connectors. Up to four 1000/100/10
Base-T Ethernet interfaces are supported. The Ethernet ports can support both data and
in-band video services on all four interfaces.
Power input POWER This connection is provided through the power connector. A power cable fitted with a barrel
connector is used to make the connection.
Reset button RESET Pressing the Reset button for less than 10 seconds reboots the ONT; pressing the Reset
button for 10 seconds resets the ONT to the factory defaults, except for the LOID and SLID.
WLAN button WLAN Wi-Fi service is compliant with IEEE 802.11 standards and is enabled and disabled using the
WLAN button.
WPS button WPS The Wi-Fi Protected Setup (WPS) button enables and disables the WPS.
LED button LED The LED button turns the LED indicators on or off.
On/Off button ON/OFF This button turns the ONT on or off.
USB port USB This connection is provided through 1 USB port on the side of the ONT. The ONT supports
external USB hard drives that can be made accessible to all LAN devices.
Fiber optic port The SC/APC fiber optic port is located at the back of the ONT and provides the connection for
the fiber optic cable.
Notes:
1. The primary path for the earth ground for these ONTs is provided by the 12V Return signal in the power
connector.
5.6 XS-2426X-A LEDs
Figure 5-3, “XS-2426X-A indoor ONT LEDs” (p. 53) shows the XS-2426X-A indoor ONT LEDs.
XS-2426X-A unit data sheet
XS-2426X-A LEDs
Nokia ONT
Review Review
© 2021 Nokia. Nokia Confidential Information
Use subject to agreed restrictions on disclosure and use.
3FE-49546-AAAA-TCZZA
December 2021
52 Issue 1
To Next Page
Loading...
